Difference between revisions of "IPv6"

From Linux-VServer

Jump to: navigation, search
Line 4: Line 4:
  
  
Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches.  You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches.  There is no need to add the prefix into <code>/etc/vservers/<guest>/interfaces/X/prefix</code>.
+
Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches.  You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches.
  
 
==Dual-Stack==
 
==Dual-Stack==
 
If you want both IPv6 and IPv4 addresses, just use IPv6 on one interface and create another interface with IPv4.
 
If you want both IPv6 and IPv4 addresses, just use IPv6 on one interface and create another interface with IPv4.

Revision as of 14:58, 15 July 2010

At the time of this writing, IPv6 support in guests requires you to apply an additional patch on top of the Linux-VServer patch. The IPv6 patch can be fetched from the official source: Bruno Prémont's IPv6 patches, and sometimes rediffs against later kernels are available from my patch directory.

To use the patch, you need util-vserver 0.30.212 or newer. These versions support IPv6 natively, so you just need to put the address in /etc/vservers/<guest>/interfaces/X/ip and start the guest to get it an IPv6 address.


Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches. You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches.

Dual-Stack

If you want both IPv6 and IPv4 addresses, just use IPv6 on one interface and create another interface with IPv4.

Personal tools