Difference between revisions of "IPv6"

From Linux-VServer

Jump to: navigation, search
(Dual-Stack)
(Dual-Stack)
Line 8: Line 8:
 
==Dual-Stack==
 
==Dual-Stack==
 
If you want both IPv6 and IPv4 addresses, just use IPv4 on one interface (e.g. interfaces/0) and create another interface (e.g. interfaces/1) with IPv6.
 
If you want both IPv6 and IPv4 addresses, just use IPv4 on one interface (e.g. interfaces/0) and create another interface (e.g. interfaces/1) with IPv6.
 +
 +
== Loopback isolation ==
 +
There is currently no loopback isolation (as it is for IPv4) available for IPv6.

Revision as of 15:44, 15 July 2010

At the time of this writing, IPv6 support in guests requires you to apply an additional patch on top of the Linux-VServer patch. The IPv6 patch can be fetched from the official source: Bruno Prémont's IPv6 patches, and sometimes rediffs against later kernels are available from my patch directory.

To use the patch, you need util-vserver 0.30.212 or newer. These versions support IPv6 natively, so you just need to put the address in /etc/vservers/<guest>/interfaces/X/ip and start the guest to get it an IPv6 address.


Starting with linux-vserver-2.3 IPv6 support is included in the main source code. No need to apply any extra patches. You will need to have util-vserver 0.30.214 or newer if you are using the 2.3+ patches.

Dual-Stack

If you want both IPv6 and IPv4 addresses, just use IPv4 on one interface (e.g. interfaces/0) and create another interface (e.g. interfaces/1) with IPv6.

Loopback isolation

There is currently no loopback isolation (as it is for IPv4) available for IPv6.

Personal tools